CAD Development : 2430


CAD / Development / 2430	2429 \| 2431

Subject:	Re: Part number needed & New primitive submission
Newsgroups:	lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev
Date:	Wed, 28 Jul 1999 13:07:44 GMT
Viewed:	77 times

On Sun, 25 Jul 1999 14:58:32 GMT, Tore Eriksson <tore.eriksson@mbox325.swipnet.se> wrote: > The new primitive seems ok, too. Very unusual that it starts from the center and > goes from -0.5 to 0.5 in all directions. I don't know if I like it, but I can > surely live with it. I think the box should conform to the same geometry as the other box* primitives -- it should range from -1 to +1, not -.5 to +.5. Steve

Message has 1 Reply:

		Re: Part number needed & New primitive submission
(...) center and (...) can (...) The way this primitive is designed saves time for the part author (not a whole lot, but some). Once you have the dimensions you want you just plug those in directly without having to divide them by two. When you use (...) (25 years ago, 28-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)

Message is in Reply To:

		Re: Part number needed & New primitive submission
Never seen the part in question, but it looks ok. The new primitive seems ok, too. Very unusual that it starts from the center and goes from -0.5 to 0.5 in all directions. I don't know if I like it, but I can surely live with it. I like the name. nl (...) (25 years ago, 25-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)

31 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search