 | | Re: Is Ldraw FAQ mistaken...?
|
|
(...) Umm, I dunno. Lemme check a second... Without actually running data through the logic, you appear to be correct. The code is comparing the second two points to the line through the first two points. (...) Could be. How tired and hungry are (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: VOTING now working
|
|
I use the same voting policy as Steve, and there were lots I had to abstain on (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Is Ldraw FAQ mistaken...?
|
|
(URL) states: Optional-Line command. Draws a line between the first two points, if the projections of both points onto the screen are on the same side of an imaginary line between the projections of the last two points onto the screen. Shouldn't it (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
(...) True, you wouldn't be able to use the related part numbers as parts, but you could search for them (especially once some software uses the KEYWORDS and CATEGORY meta-commands) (...) That would be the problem. Are these real parts, or not? If (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: VOTING now working
|
|
BTW, does everyone use the Abstain option? I will generally abstain on any piece I don't have, unless there are obvious problems with a part. Steve (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) Ah. That clears it up. I'll dig up one of these pieces when I get home, to be sure I understand. Steve (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
(...) about (...) part (...) That still wouldn't make it possible in Ldraw to (I)nsert a new piece, change the (P)art number, then type the part number of the part which is in your hand, and have it inserted. Multi-part parts are a problem, of (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) I probably did a bad job at explaining what is wrong. Looking at the 2853 part with the grey axle pointing towards you, you'll see a round hole in the grey surface next to the axle which sticks out. (This hole is rectangular on some versions (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | RE: part: panel 1 x 2 x 1 with black grille pattern
|
|
(...) I think it is a bad tendency if we are going to speculate in specific rendering programs: adding extra drawing commands, so that at least some of them will show under certain circumstances. Hints for specific rendering techniques should be (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) I'm not following the problem, here. It may because I don't have one of these pieces to look at, but I'm not seeing what shows through, and if something did show through, how having rounded-end axles would help. I modified your code to use a (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
