Subject:
|
Re: parts wanted
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 1 Mar 1999 17:45:33 GMT
|
Viewed:
|
1480 times
|
| |
|
|
On Mon, 1 Mar 1999 16:13:48 GMT, Fredrik Glöckner
<fredrik.glockner@bio.uio.no> wrote:
> blisses@worldnet.att.net (Steve Bliss) writes:
>
> > On Mon, 1 Mar 1999 08:40:46 GMT, Fredrik Glöckner
> > <fredrik.glockner@bio.uio.no> wrote:
> >
> > > at the website
> > >
> > > http://www.math.uio.no/~fredrigl/technic/ldraw/
> > >
> > > BTW, the part "2853 Technic Crankshaft" is probably "impossible" to make
> > > properly in LDraw. This is because of the way the Technic axles are
> > > constructed in LDraw; the ends are not rounded as in real life.
> >
> > I'm not following the problem, here.
>
> I probably did a bad job at explaining what is wrong.
>
> Looking at the 2853 part with the grey axle pointing towards you, you'll
> see a round hole in the grey surface next to the axle which sticks out.
> (This hole is rectangular on some versions of the part, but it doesn't
> make it any more easy.)
>
> Now, the problem I experienced is this. Put an axle into the axle hole
> on the other side of the part. This axle protrudes 10 LDU's into the
> 2853 part. Ideally, the only part of this axle visible should be a
> round disc, visible through the round hole on the front, the hole I
> mentioned in the paragraph above. But with the "collar" of the part
> being 10 LDU thick, which is the correct thing, not only the round disc,
> but also the outline of the axle end is visible. This happens because
> the surface of the 2853 part and the surface of the axle end are
> coincident.
>
> What you see may differ due to various parameters, such as rendering
> program used, viewpoint and so on. I remember getting a dirty surface
> where the two coincident surfaces met.
>
> I hope this was more clear. Please ask more questions if it is not.
Ah. That clears it up. I'll dig up one of these pieces when I get
home, to be sure I understand.
Steve
|
|
Message is in Reply To:
 | | Re: parts wanted
|
| (...) I probably did a bad job at explaining what is wrong. Looking at the 2853 part with the grey axle pointing towards you, you'll see a round hole in the grey surface next to the axle which sticks out. (This hole is rectangular on some versions (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
