Subject:
|
Re: Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sun, 19 Sep 2004 18:45:25 GMT
|
Viewed:
|
4961 times
|
| |
|
|
In lugnet.cad.dat.parts, Edwin Pilobello wrote:
| |
Finally, my fair (if not terrible) first attempt at part authoring is ready
for • submission (as soon as parts@ldraw.org lets me).
What a learning experience! It took 12 version saves to get “close”. And I’m
sure there’s more to learn after the reviews come in.
|
Looks good. You chose a relativle simple part for your first, unlike me:
| |
1. Parts 41855 and 47457 have 4 pairs of 1 LDU ridges/clips opposite on each
corner. s41855s01 does not represent them. Should it? Is there a specific
primitive or do I use a cuboid to represent these ridges/clips in 47457?
|
Don’t worry about those. They’re non-funtional and insignificant
| |
3. MORE IMPORTANTLY, how to I get a good measurement on the inside curve? My
caliper’s wire tail is not pointed so I had to guess by adding 1 LDU.
|
Guessing is fine as long as you’re not too far off.
-Orion
|
|
Message has 1 Reply:
 | | Re: Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
| (...) My goodness, that was one massive scary part! I'm going to look that up and see how many lines it took! I would have chosen the click rotation joint. I figured I needed a very simple part to warm up. Talking about "not too far off", should I (...) (21 years ago, 20-Sep-04, to lugnet.cad.dat.parts, FTX)
|
Message is in Reply To:
| | Creating 47457.dat 2x2x2/3 Sloped&Rounded [DAT]
|
| Finally, my fair (if not terrible) first attempt at part authoring is ready for submission (as soon as parts@ldraw.org lets me). What a learning experience! It took 12 version saves to get "close". And I'm sure there's more to learn after the (...) (21 years ago, 19-Sep-04, to lugnet.cad.dat.parts)
|
16 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
