Subject:
|
Re: Idea for a new feature to help rotation of parts in Ldraw Cad software
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 24 Aug 2000 07:25:11 GMT
|
Viewed:
|
729 times
|
| |
|
|
In lugnet.cad, Marc Klein writes:
<SNIP>
> The rotation axis defines a rotation center and limits the rotation to one • degree of freedom. It should be used in
> primitives that basically only have only one degree of freedom in rotation • like pegholes and axleholes. This feature
> will avoid to freely turn around a point where it is only possible to turn • around an axis and so limit the misplacement
> of parts.
> Most of the rotation of parts are only around one axis.
> Marc Klein
> A Mindstorms fan.
I think this is not true, you can rotate any part however you like, since
there are a lot of parts which allow to connect other parts in various angles.
E.g. this thing with two plates (don't know how it's called in english) which
can be opened up to 270 degrees - the plates are connected with an axis.
Theire are also parts which connect two parts in an angle of 90 degree ...
Michael
|
|
Message has 1 Reply:
Message is in Reply To:
12 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
