Subject:
|
Re: Official LPub manual online
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 25 May 2011 20:53:02 GMT
|
Viewed:
|
20364 times
|
| |
|
|
In lugnet.cad, Saso Tomat wrote:
| |
I need a help with Lpub. I just can’t get it to work (checked the manual
already). I am posting this here so maybe manual could get an update if
necessary.
|
--snip--
| |
These gives me such instructions:
|
--snip--
| |
I would like have two separate instructions (in one .pdf at the end). Like
these are two separate models. First I would like to build red model and then
the yellow model.
I would like to have an image of a complete model and then it should start
with step 1 and previous model (red) should not be visible.
Something like this (edited with Paint):
|
--snip--
There’s two ways I can think of.
1) Make the two sections into submodels. Although that will force them onto
different pages. But you can always hand edit them back
2) Use buffer exchange to mask one bit and then the other. I’m no expert on this
so can’t say much more.
Tim
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Official LPub manual online [DAT]
|
| I need a help with Lpub. I just can't get it to work (checked the manual already). I am posting this here so maybe manual could get an update if necessary. 0 Untitled 0 Name: example.ldr 0 Author: MLCad 0 Unofficial Model 0 ROTATION CENTER 0 0 0 1 (...) (13 years ago, 25-May-11, to lugnet.cad, FTX)
|
16 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
