Subject:
|
Re: LPub4 Alpha3 available
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 15 Jun 2008 04:24:59 GMT
|
Viewed:
|
5607 times
|
| |
|
|
In lugnet.cad, Travis Cobbs wrote:
| |
OK, I tried it on a clean machine, and it does indeed work. I did find a few
more problems, though:
- It apparently requires certain settings to be set in LDView a certain way. I’m not sure what those settings are, or what values are needed, but when I tried it on the clean machine, I didn’t get any images out of LDView. However, on my main machine, it works fine with LDView 3.1 (the release version).
|
Scratch that. That was due to a screw-up on my part. I somehow managed to
install LDView 3.1 instead of LDView 3.2. After installing LDView 3.2, it works
fine.
--Travis
|
|
Message is in Reply To:
 | | Re: LPub4 Alpha3 available
|
| OK, I tried it on a clean machine, and it does indeed work. I did find a few more problems, though: If you hit cancel during LDraw directory selection, it just comes back again (repeatedly). (This machine didn't have LDraw, so I tried to cancel; I (...) (16 years ago, 14-Jun-08, to lugnet.cad, FTX)
|
44 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
