Subject:
|
Re: Ldraw/MLCAD question
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 14 May 2003 15:10:03 GMT
|
Viewed:
|
641 times
|
| |
|
|
This discussion about raised a suggestion for a
nice feature for MLCad (and perhaps also for other
LDraw building software):
A possibility to filter all patterned bricks.
And have this filter be enabled and disabled with
a press of a button. (The filter might work on
searching for a 'p' in the part's filename)
When building plain walls or so in MLCad it can get
quite annoying to have to browse through all those
patterned bricks. So filtering all patterned bricks
out saves a lot of time when building. And when you
need a patterned brick, just disable the filter and
you can browse all parts.
Niels
|
|
Message has 1 Reply:
 | | Re: Ldraw/MLCAD question
|
| (...) Have you looked at the "group configuration options"? I think it's on the Tools menu (or maybe Extras). I use this feature to separate out "unmodified" bricks and plates into "Bricks" and "Plates" categories, and the modified ones go into (...) (22 years ago, 14-May-03, to lugnet.cad)
|
Message is in Reply To:
| | Re: Ldraw/MLCAD question
|
| (...) The hard way: Open the file C:\LDraw\PARTS.LST. Find the entries you don't want, and manually remove them. You won't see them on the parts list in any LDraw-based program you use, but if you're never going to use them...it'll work. (note, each (...) (22 years ago, 14-May-03, to lugnet.cad)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
