| |
> I didn't see a way in the document to
> turn bothe control lines to 9v, but they can bothe or individually be set to
> 0v!
Either single pin modes allow to set each output to 1 (9V) or 0 (0V).
>
> Does anyone know how much current the control lines can supply/sink?
See the drive datasheet: http://www.philohome.com/nxtpwr/lb1836M.pdf
Current can reach 1A peak, continuous value is lower (500-600mA) especially if
both outputs are heavily loaded at the same time.
Philo
|
|
Message is in Reply To:
19 Messages in This Thread:
  
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
