Subject:
|
Re: Reed sensors are not working very well (or too well?)
|
Newsgroups:
|
lugnet.org.ca.vlc, lugnet.trains
|
Date:
|
Fri, 27 Jul 2001 12:30:01 GMT
|
Viewed:
|
40 times
|
| |
|
|
"steve barile" <steve.e.barile@intel.com> wrote:
> I know this has been covered in the past, but can you point me to info on
> the reed switch used and implmentation notes. Thanks
This is the original message by Chris Phillips:
http://news.lugnet.com/trains/?n=8544
In my version, following John Barnes's suggestion, I put a 100 ohm resistor
in series with the reeds. The devices are very low current, and if you make
a wiring error and connect them to an output or a battery pack, you will
weld them closed! The RCX doesn't expect 0 ohm touch switches and works
pretty well with them.
Mario
|
|
Message is in Reply To:
17 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
