Subject:
|
Re: Reed sensors are not working very well (or too well?)
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Thu, 26 Jul 2001 17:35:25 GMT
|
Viewed:
|
1219 times
|
| |
|
|
Robin Sather wrote:
> > I've since asked that it be moved to the side where it can be triggered via
> > the side. I'll be doing testing today on that.
>
> Dean, I've put a magnet mounted in the middle of the first car (not
> the engine or tender). It's vertically just above the wheel hubs
> halfway between the bottom of the car and the top of the track. The
> face of the magnet sticks out ever so slightly beyond the side of the
> track itself, but not all the way to the side of the actual tie.
Our widest trains are 8 studs wide right? So that puts it to the end of the
track. I'll make a little building with the switch recessed. How high is it from
the table to where the center of the switch is? I'll need this to setup the
height's.
This should work. It's not ugly is it?
Dean
|
|
Message is in Reply To:
17 Messages in This Thread:
  
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
