LEGO SYSTEM Trains : 12075


Trains / 12075	12074 \| 12076

Subject:	Re: 2x2 turntables vs 2x2-with-pin plates was Re: Un-powered replacement for train motor
Newsgroups:	lugnet.trains
Date:	Wed, 4 Jul 2001 09:12:03 GMT
Viewed:	560 times

In lugnet.trains, Christopher Masi writes: > I was going to use the 2x2-with-pin plate in my designs too, but I found the > 2x2-with-pin plate to make my cars to tippy. What you need to do is put some tiles around the pin-plate. Not right to the ends of the bogus motor block, but about the 6x6 size of a normal bogey plate. If you do take the tiles right to the end, it won't rotate properly under the wagon plate. Jason J Railton

Message has 1 Reply:

		Re: 2x2 turntables vs 2x2-with-pin plates was Re: Un-powered replacement for train motor
(...) Oops, I meant 6x4. I find if you're centreing the pin plate you can tile a 7x4 area around it without having any turning problems on a 6x28 baseplate. It's a shame those old 2x3 helicopter rotor mounts don't have the right size pin on them. (...) (23 years ago, 4-Jul-01, to lugnet.trains)

Message is in Reply To:

		2x2 turntables vs 2x2-with-pin plates was Re: Un-powered replacement for train motor
(...) I was going to use the 2x2-with-pin plate in my designs too, but I found the 2x2-with-pin plate to make my cars to tippy. When I made my double-stack well cars (what is the right name for those?) I decided to try the 2x2-with-pin plate to put (...) (23 years ago, 3-Jul-01, to lugnet.trains)

11 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search