Message has 4 Replies:
 | | Re: Un-powered replacement for train motor
|
| (...) In my eyes the half stud offset in length direction is less worse than the one plte offest in height. But you can build a nearly 100% replacement if you do not use the bogie plate, but tiles and for e.g. this part: (URL) hole of this plate is (...) (23 years ago, 2-Jul-01, to lugnet.trains)
| | | Re: Un-powered replacement for train motor
|
| (...) Looks good, but I find the truck arrangement used in set 4564 to be pretty good, if you fill in the spaces between the wheels with 1x4 and 2x4 bricks. I use this arrangement on my v188 double-diesel. -Harvey (23 years ago, 2-Jul-01, to lugnet.trains)
| | | Re: Un-powered replacement for train motor
|
| Cool, I was working on one of these too. (URL) did mine a little differently. By replacing the bogie plate with a 2x2 plate with a pin out the top, the 1x2 plates with the center bump could be placed in the groove part of the train wheels. This (...) (23 years ago, 3-Jul-01, to lugnet.trains)
|
11 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
