| | Re: Looking for review of 4555
|
|
(...) I think it's a good set but just a tad overpriced. Didn't stop me from getting 3 though. YMMV. (26 years ago, 2-Dec-98, to lugnet.trains)
|
|
| | Looking for review of 4555
|
|
I've posted a copy in the review section but since there isn't much traffic there and since it is train related I posted here too. I hope that is okay. I'm a bit new to the train department and I am contemplating buying this set, 4555, freight (...) (26 years ago, 2-Dec-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
On Wed, 2 Dec 1998 08:18:52 GMT, "Eric Brok" <brok@fcjsvc.hvu.nl> wrote: :Ofcourse, LEGO has to deal with a lot of reverse compatibility. For better :or for worse. (Changing from 9V to 12V was a big exception but even that was :aimed at moving to (...) (26 years ago, 2-Dec-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
Jasper Janssen wrote in message <3664650f.17422672@l...et.com>... (...) Ofcourse, LEGO has to deal with a lot of reverse compatibility. For better or for worse. (Changing from 9V to 12V was a big exception but even that was aimed at moving to one (...) (26 years ago, 2-Dec-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Larry, I will be travelling Amtrak in January, from Chicago to Lincoln, Illinois. If I have a choice, should I go Metroliner if available?? (sorry everyone! But seeing him in trains reminded me to ask! Plus, I would have a Lego frame of reference!) (...) (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
On Mon, 30 Nov 1998 22:54:31 GMT, "Matthew Bates" <train_depot@yahoo.com> wrote: :Jasper Janssen writes: : >I stopped Lego before 9V trains came out - Does this mean LEgo 9V uses :>PWM instead of just reducing the voiltage to 0? my 12V transformer (...) (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | Re: Train Tables, and my Round House
|
|
Hello, I am just about to router a circular hole near the middle of a large modular table. (Built based on Bens design) When I built it, I modified it for this purpose, I did not place a crossbrace in the middle, but rather put crossbraces at one (...) (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | Train Tables, and my Round House
|
|
Well, I finally had a few rainy days to try to finish building my LEGO Train Tables (following Ben's original design). ftp://jeffk.com/pub/...lding.html I started to put my Round House onto the table, and remembered that I'd want to imbed the (...) (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | 4552 to be Discontinued?
|
|
Are train sets discontinued as frequently as other system sets? I'm interested in #4552 Cargo Crane (available from S@H only), but I'm over my LEGO budget for quite a ways into next year. Should I borrow? DJ Zorn (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | Re: sticker shock
|
|
On Sun, 29 Nov 1998 20:06:05 GMT, "Ben Fleskes" <benfleskes@msn.com> wrote: :Fully agreed. I see this all the time at the train shows PNLTC goes to. :People spending small fortunes to buy an engine or a car simply to run it :around a track. Well I (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
Jasper Janssen writes: >I stopped Lego before 9V trains came out - Does this mean LEgo 9V uses (...) No they aren't PWM, they vary the voltage between 0 and 9V See (URL) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: Track Switch solenoids
|
|
On Thu, 19 Nov 1998 01:39:31 GMT, Larry Andersen <neonglass@earthlink.net> wrote: :My problem with using pneumatics for the job is that the pistons stick :after sitting for a while. You have to break them loose manualy before :they will work (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
On Thu, 19 Nov 1998 04:24:02 GMT, Mark Harrison <harro1@one.net.au> wrote: :The reason this is of interest to me is that I have always wanted to use :12V lighting sets with my 9V setup but as the regulators always said :9-10V I thought it would not (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A better boxcar? (was: Re: Thanks to Terry Cruse and Ali V.
|
|
On Fri, 6 Nov 1998 20:42:39 GMT, "Dan Parker" <danp@qi2.com> wrote: :I must agree with Ben -- and this might be a little more blunt. As much of a :LEGO trainhead that I am, I find it difficult to justify building a shrine to :the 9v series in its (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Yes, it uses two 1x2/1x4 angle brackets. both attach to a 2x6 plate. The two medium slopes attach to either side and a non rotating magnet base attaches to the middle with a couple of 2x2 plates to space it out far enough. The upper angle bracket (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
The color scheme is Red (main body), with yellow,blue,yellow striping. I consider the model a prototype. I'd like to build another based on the same body to reflect a actual freight engine. <snip> (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Thanks Tony. Thats pretty high praise since you seem generally pretty reserved about giving it. (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Ben Fleskes wrote in message ... (...) locomotive. (...) Nice work. I've admired your other designs in silence, but now I feel the time has come to say: you are one talented motherfucker. Keep up the good work. (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
(...) OK, I did some more digging. The GM site is pretty sparse but check out this link: (URL) right picture (the SD70 MAC) also looks like your loco, same bulging rear radiators. GM and GE are getting harder to tell apart these days. Note that the (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
(...) I like it. The truck mounted front coupler with side slopes is a good idea, how'd you do it? 1x2/1x4 angle bracket? Note that I have a body mounted front coupler that looks similar on big red... but it's not very sturdy. How sturdy is yours? (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|