LEGO TECHNIC : 9328


Technic / 9328	9327 \| 9329

Subject:	Re: what else could be done
Newsgroups:	lugnet.dear-lego, lugnet.technic
Date:	Wed, 19 Feb 2003 07:08:51 GMT
Viewed:	329 times

<<snip>> > • 1x3 traditional Technic beam Would that use holes between the studs or right below them? Like this http://peeron.com/inv/parts/3700 or this http://peeron.com/inv/parts/32000 or both kinds? Best regards, /Tobbe http://www.lotek.nu (remove SPAM when e-mailing)

Message has 2 Replies:

		Re: what else could be done
"Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:HAJnus.66L@lugnet.com... (...) right below can be done using 1x2 technic bric with 2 holes + 1x1 brick with hole so you know you will never see a coin with value 3 :)) 1x3 brick with 2 holes (...) (22 years ago, 19-Feb-03, to lugnet.dear-lego, lugnet.technic)

		Re: what else could be done
(...) Well, I was originally thinking holes b/w the studs (for a total of 2 holes), but I suppose a 3-hole (holes right below studs) would be cool too :-) TJ (22 years ago, 19-Feb-03, to lugnet.dear-lego, lugnet.technic)

Message is in Reply To:

		Re: what else could be done
Geesh, not THIS discussion again :-) Well, I guess it's about time for the "new parts wish list" to come back around for discussion! • Bring back threaded axels in different sizes (I know non-Lego threaded nylon shafts are available, so this is for (...) (22 years ago, 18-Feb-03, to lugnet.dear-lego, lugnet.technic)

15 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search