| |
Geesh, not THIS discussion again :-)
Well, I guess it's about time for the "new parts wish list" to come back
around for discussion!
• Bring back threaded axels in different sizes (I know non-Lego threaded
nylon shafts are available, so this is for the purists :-)
• A small bearing assembly for large wheels (sorta like this:
http://www.bricklink.com/catalogItem.asp?P=bb74 but more simple- just for
bearing support so the wheel won't slide off your axle or wobble too much)
• 1x2, 1x3, 1x4 Liftarms with all smooth holes
• 1x4 studless beams with all smoth holes
• 1x3 traditional Technic beam
In lugnet.dear-lego, Paul Krieg writes:
> Hello,
> I would like to see:
> A female towball pin to fit on an axle.
Ditto to that. Plus a variation that uses a friction peg to be fitted in a
smooth hole.
Always wishing...
-TJ
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: what else could be done
|
| Hello, I would like to see: Packets or tubes that contain the correct lubricant for the pneumatic cylinders, pumps, and valves. A female towball pin to fit on an axle. A spool/slider valve for pneumatics. A gear perhaps in various sizes with a round (...) (22 years ago, 17-Feb-03, to lugnet.dear-lego, lugnet.technic)
|
15 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
