Subject:
|
Re: 8860 Scissors lift
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 3 Jun 2001 16:25:41 GMT
|
Viewed:
|
3504 times
|
| |
|
|
In lugnet.technic, Selçuk Göre writes:
> The weirdest mistake in a Lego instruction I've ever seen is this:
>
> http://www.brickshelf.com/scans/8000/8880/8880-049.html
>
> Look at the second step in mirror subassembly. Look at the 1x1 bricks
> (both the one with hole and the regular one) How this could be possible
> if they are using a 3D CAD program to prepare instructions?
>
> Selçuk
How did you notice this? It's such a minute mistake!
Notice that the opposite mirror in the lower subassembly is fine and in fact
it's the same as the upper one (instead of being a mirror image) except for the
hole. Perhaps that's a clue as to how they actually do the instructions.
Maybe they have a basic brick and they can add holes and other features to it.
- David
|
|
Message has 1 Reply:
 | | Re: 8860 Scissors lift
|
| (...) talking of minute mistakes - here's another. (it was probably a late alteration, so they didn't bother correcting the other steps) (URL) look at the 2x1 plates in stage 7. Then look at what has happened to them by here... (URL) this is also (...) (23 years ago, 4-Jun-01, to lugnet.technic)
|
Message is in Reply To:
| | Re: 8860 Scissors lift
|
| The weirdest mistake in a Lego instruction I've ever seen is this: (URL) at the second step in mirror subassembly. Look at the 1x1 bricks (both the one with hole and the regular one) How this could be possible if they are using a 3D CAD program to (...) (23 years ago, 3-Jun-01, to lugnet.technic)
|
18 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
