Subject:
|
Re: How to strengthen friction peg?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sat, 19 May 2001 07:07:26 GMT
|
Viewed:
|
710 times
|
| |
|
|
Purists will wretch, but I've found that running a #4-40 screw through the
center and securing it with 2washers, a lockwasher, & a nut works *VERY*
well...
Flame me if you must, but it's better than breaking precious LEGO(R) parts
: )
"Steve Runnels" <netfreak16@hotmail.com> wrote in message
news:GDGEII.1x2@lugnet.com...
> Well, I've tried putting paper into the peg several different ways to try • to
> make it stiffer, but the paper loosens up after awhile...
>
> Some joints just don't have room (functionaly or estheticaly) for anything
> but a simple friction peg, but they have JUST enough weight for the joint
> not to hold...
>
> Any other tips?
>
> Thanks
|
|
Message is in Reply To:
 | | How to strengthen friction peg?
|
| Well, I've tried putting paper into the peg several different ways to try to make it stiffer, but the paper loosens up after awhile... Some joints just don't have room (functionaly or estheticaly) for anything but a simple friction peg, but they (...) (24 years ago, 17-May-01, to lugnet.technic)
|
16 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
