Subject:
|
Re: Radial Engine (and V8 crankshaft)
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 20 Feb 2005 04:24:03 GMT
|
Viewed:
|
3489 times
|
| |
|
|
In lugnet.technic, Ross Crawford wrote:
| |
In lugnet.technic, Nathan Bell wrote:
| |
Now if someone can figure out a way to arrange a
(Lego) V8 crankshaft to bend 4 directions instead of 2, I will repent from
the sin of butchering Legos!
|
Here is my V8 with 5 bearings. It has standard small block chev firing order,
and uses the FOS system to simulate spark plugs/injectors. The only downside
is that using the Technic mounts means it doesn’t have the correct 90 degree
angle between cylinder heads.
|
i’ve seen the FOS system used before that way ;)
http://www.brickshelf.com/cgi-bin/gallery.cgi?f=20105
The mpeg is not working the last time I looked. I can email it to anyone
interested.
Back to the radial engine, the design for the crankshaft is very nicely done.
Any plans to put it in a model?
|
|
Message is in Reply To:
 | | Re: Radial Engine (and V8 crankshaft)
|
| (...) Here is my V8 with 5 bearings. It has standard small block chev firing order, and uses the FOS system to simulate spark plugs/injectors. The only downside is that using the Technic mounts means it doesn't have the correct 90 degree angle (...) (20 years ago, 19-Feb-05, to lugnet.technic, FTX)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
