Subject:
|
Re: Has Anyone Joined the Dark Side Yet?
|
Newsgroups:
|
lugnet.general, lugnet.starwars
|
Date:
|
Sat, 22 Jul 2000 13:34:30 GMT
|
Viewed:
|
23 times
|
| |
|
|
In lugnet.general, Mark D. McKean writes:
> In article <3978FE3D.F2E93FE0@vfaq.com>, "Tom Stangl, VFAQman"
> <talonts@vfaq.com> wrote:
> Hmm...then how does the X-wing sit on its display stand? If some less
> stable combination of bricks is used, that might account for the reports
> I've seen of X-Wings falling off their stands...short of earthquake or
> deliberate bumping, that TIE is *not* falling off its stand.
There is a square hole built up by plates... in reality, it is very very
stable. As for reports of the x-wing falling off, well, it is a much much
heavier model than the UCS TIE. It hasn't happened to mine, but I can see how,
if the stand is placed in it's forward position (horizontal flight), the center
of mass of the model + stand is too high for perfect stability, and the whole
thing could topple over.
BTW, if you put the UCS TIE on a glass table in the horizontal stand position,
it also has a tendency to want to topple over, albeit not as readily as the UCS
X-wing.
--Karim
|
|
Message is in Reply To:
 | | Re: Has Anyone Joined the Dark Side Yet?
|
| (...) Hmm...then how does the X-wing sit on its display stand? If some less stable combination of bricks is used, that might account for the reports I've seen of X-Wings falling off their stands...short of earthquake or deliberate bumping, that TIE (...) (24 years ago, 22-Jul-00, to lugnet.general, lugnet.starwars)
|
20 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
