To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.spaceOpen lugnet.space in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Space / 36440
36439  |  36441
Subject: 
Re: A little introduction and two MOCs
Newsgroups: 
lugnet.space
Date: 
Mon, 4 Oct 2004 09:58:24 GMT
Viewed: 
3861 times
  
In lugnet.space, Joel Larsson wrote:
> In lugnet.space, Niels Bugge wrote:
> > Hi Joel, welcome out of the shadow and into the sunny part of space!
> > 
> > I’ve only got time to look at the Siberia, as I’m about to leave town for the
> > weekend, but I think you have some good snot going on there.
> > I’ve only got two complaints: First, I think the cockpit is too large and
> > squarish compared to the rest of the craft that’s more of a slender cone.
> > Secondly, it may droop a bit too much compared to the general direction of the
> > slender cone, but I’m not so sure as I need a good sideshot of it all.
> > 
> > If you want maximize the effect of the snotwork, you might consider varying the
> > levels of some of the surfaces.
> > 
> > All in all a nice ship, and the grille/chairs on top is something I’ll
> > definitely remember for some other time.
> > 
> > -NB
> 
> Thanks for the comments
> Yeah I know about the cockpit, but i couldn't find a good way to connect it at a
> straighter angle. But the parts just fell into place and this was the result. I
> am innocent =) But as I said to Tony, I am thinking about a remake.

You can reduce the width of the cockpit by using plates on the sides instead of
an extra layer of bricks outside the 4-wide windscreen. I think the angle is
fine, but it must be possible to take some of the bottom (and drooping) off?

BTW I like the Endeavour a lot, but I think you should continue the grey greeble
part "below the waterline" down into the brown part, that would make the moc
look more integrated.

-NB



Message is in Reply To:
  Re: A little introduction and two MOCs
 
(...) Thanks for the comments Yeah I know about the cockpit, but i couldn't find a good way to connect it at a straighter angle. But the parts just fell into place and this was the result. I am innocent =) But as I said to Tony, I am thinking about (...) (22 years ago, 3-Oct-04, to lugnet.space)

17 Messages in This Thread:







Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR