| |
Dave Baum wrote:
> In article <39D8B47C.E8FA0ACF@telia.com>, tobias.moller@telia.com
> wrote:
>
> > I heard it somwhere too, so I assumed it could be done, however, I
> > haven't downloaded the new firmware, so I don't know.
>
>
> After looking over the docs again, I'm fairly certain it can't be done
> (or at the very least isn't documented). If anyone finds out how to do
> it, let me know and I'll add support to NQC.
Dave, I have a question about the datalog. In the manual you state that the
createdatalog function creates a datalog of x many points. How much is a
point? Is that how many unique entries can be made or an overall 'byte'
amount? Is a value like 4 or 123456 equal as a single entry?
One last issue, with the RCX you can set up the IR port as a serial
protocol. 2400 baud etc... But I don't see any way of receiving this info
with another RCX. Is this for RCX -> PC only?
Dean
--
Coin-Op's For Sale!: http://www.akasa.bc.ca/tfm/coin-op.html
Dean's Lego Workshop: http://www.akasa.bc.ca/tfm/lego_wr.html
Vancouver Lego Club: http://www.akasa.bc.ca/vlc
|
|
Message has 1 Reply:
 | | Re: The datalog
|
| (...) Each call to AddToDatalog() uses up one "point". Each point takes up 3 bytes of memory: a 1-byte code for the source of point (sensor, timer, etc), then a 2-byte value. 123456 is too big to fit into the log. This would either generate a (...) (24 years ago, 4-Oct-00, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | Re: The datalog
|
| (...) After looking over the docs again, I'm fairly certain it can't be done (or at the very least isn't documented). If anyone finds out how to do it, let me know and I'll add support to NQC. Dave (24 years ago, 3-Oct-00, to lugnet.robotics.rcx.nqc)
|
16 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
