Subject:
|
Re: Training OmniRemote for RCX commands
|
Newsgroups:
|
lugnet.robotics.palm
|
Date:
|
Fri, 10 Dec 1999 13:49:45 GMT
|
Viewed:
|
2766 times
|
| |
|
|
snip...
>
> It appears that the protocol from the RCX transmitter
> tower is not consistant, so OmniRemote can't always pin it down. Just a
> guess.
I don't have OmniRemote but this may help.
The normal RCX commands are not consistent. When you send the same command
repeatedly, the command is slightly different on alternate commands. In
other words the first time it sends "A" then "B" then back to "A" then "B"
etc. Also, the RCX sends commands back to the Tower on normal commands. This
may also cause some confusion.
If you use the Remote Control commands you can get around all of these
problems. They are always the same and the RCX doesn't send a response.
--Mike
|
|
Message has 1 Reply:
 | | Re: Training OmniRemote for RCX commands
|
| (...) That's good advice. I forgot to mention to Ed that having the RCX on will confuse OmniRemote because of the return IR from the RCX. The problem I have found with using the LEGO remote commands to train OmniRemote is the final d2 command (...) (25 years ago, 10-Dec-99, to lugnet.robotics.palm)
|
Message is in Reply To:
| | Re: Training OmniRemote for RCX commands
|
| (...) Robert, Well, so far I've only matched your efforts, and I'm unable to improve upon them. I definitely see how flakey the training procedure may be interpreted by the OmniRemote. It appears that the protocol from the RCX transmitter tower is (...) (25 years ago, 10-Dec-99, to lugnet.robotics.palm)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
