To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 6141 (+10)
  Re: wireless communication to RCX
 
Pete Sevcik writes: > A simple way to overcome the unidirectional problem of the IR link is to build > your robot with the RCX pointing up. Suspend the IR tower from the ceiling, > pointing down. Not needed. IR bounces off a white ceiling very (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Power steering for 8448
 
Matthew Miller writes: > Jacob Schultz <lego-robotics@crynwr.com> wrote: > >always measure the angle the car is driving, and control the steering so it does > >not tear the car apart. > >Right now I try to put in a touch sensor also, so the car can (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Using the Motor as a Tachometer
 
(...) Dave, this use of a motor as an input is fascinating! (How safe is it? Looking at some older threads, there seems to be a difference of opinions, or at least a non-consensus that it's safe...) I just hooked an 1x2 LEGO incandescent lamp up to (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Handy Board software
 
Over the past few months, I've been reading with great interest many of the exciting things people here have written about the Handy Board... (10 URLs) I'm really starting to think that one of these would be a great addition to my LEGO collection. (...) (27 years ago, 9-Aug-99, to lugnet.robotics, lugnet.robotics.rcx.legos)
 
  Re: Not that you care...
 
"John A. deVries II" wrote: ... (...) I hope you'll post anything intersting you find/invent to the newsgroup, since I am interested in that too and I believe there are more of us. when I get around to actually build some robot, I plan to make a big (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  RE: USB->serial adapter for IR-tower
 
(...) I have an Entrega splitter which adds two serials, a parallel, and four USB's, and it does that kind of stuff just fine. Very cool. I've run Ethernet (10BaseT), my printer, IR, and many other things through it. The best part: the fact that it (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  Re: Power steering for 8448
 
I don't have the 8448 or the RCX for that matter but I may have a partial solution for you. I've found that steering is a perfect application for the Micro Motor (part # 5119). The motor is very small but provides a surprising amount of torque. It (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  RE: Power steering for 8448
 
You should be able to get away with just a single rotation sensor. When you power up the RCX, you will not know the position of the steering. Now turn it one way until the rotation stops. You are now at the end point, and know the position of the (...) (27 years ago, 9-Aug-99, to lugnet.robotics)
 
  Re: Handy Board software
 
(...) They're both 8-bit microcontrollers with a roughly similar set of peripheral functions (timer, ACD, serial port, etc). But the similarity ends there. The programming model for the H8 is compltely different from the 68xx series. (...) I don't (...) (27 years ago, 9-Aug-99, to lugnet.robotics, lugnet.robotics.rcx.legos)
 
  Re: Using the Motor as a Tachometer
 
(...) I'm not a EE, but here's my take on the situation... Turning the motor increases the electrical potential (voltage) between its two contacts. If the motor isn't connected to anything, then its easy to turn - relatively little energy is (...) (27 years ago, 9-Aug-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR