To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 24044 (-20)
  Re: Nemesis4Lego controller
 
(...) Joe, the controller, as it is built right now, has two 3 pin ports exacly for sensors like ultrasonic, Sharp SP2D12, compass, accelerometer, etc. and servos. And I have in the works a module with a serial LCD. About my site. I just cheked it (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: BlueTooth bad, Zigbee good
 
I'm biased, so here's my rebuttal: 1. The JB-22 is a great, affordable Bluetooth development kit under $200 USD. (URL) Class 1 Bluetooth devices have a range of +300ft. Anycom makes one that is rated at 330ft, but tests have shown that it can (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  more on Zigbee
 
(...) Good question. I was comparting BT to other RF systems. But you won't typically run your motors at 100% load all the time, either. So typically on a Lego bot, motors will be the main power users. Add BT to a Lego Bot and the battery life will (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: BlueTooth bad, Zigbee good
 
(...) Anytime you have something listening for signals to wake up on, it will consume power. Even at 5 or 10 mA, you'll run through a standard AA battery pretty quickly - never mind coin cells. (...) When it came out, it was pretty cutting edge - in (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  BlueTooth bad: vendors crippling BT phones
 
(URL) much for the "use your BT phone as a modem with your BT PC or PDA". BT had a lot of hype for a long time but IMHO it's been killed for "small" users but such nonsense as the above, and the lack of affordable development tools. BT vendors (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: BlueTooth bad, Zigbee good
 
On Wed, June 1, 2005 12:29 pm, Bruce Boyes said: (...) You mean compaired to other comm devices, or compaired to a couple motors? I'd think if you have a moble robot, the motors are going to use much more power than anything else, right? (...) From (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  BlueTooth bad, Zigbee good
 
(...) Bluetooth is actually very poor for embedded or robotic applications. It's a power hog, development tools are expensive (try $5000 minimum), true peer to peer modules are almost impossible to get unless you are a Fortune 500 company, and the (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: Nemesis4Lego controller
 
(...) Gabriel, please do keep working on this! It's exactly the sort of thing I've been looking for for years. I get frustrated with the high cost and hard limits of the RCX; it sounds like your units would be far superior in terms of entry cost and (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Nemesis4Lego controller
 
Danny & all, This was a prototype that I have built with regular parts. If there will be demand, I will make and order PCBs. The total cost of the parts is around $30. Add $10 for labor (and that is verry modest) and you'll get the price. The size (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: Lego controller
 
(...) Bluetooth has a maximum range of 30 feet. That's in optimum conditions. You might get down as low as 15 feet in real world applications. At 2GHz or so, it doesn't go through walls very well either. Bluetooth is DESIGNED to have short range - (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: Lego controller
 
(...) Yeah - and my opinion can still best be described as "Make It Modular". Most of the other things people want would fall naturally out from that one design decision. (...) I doubt it - but MANY people use IR between robots (and the IR remote is (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
 
  Re: Lego controller
 
(...) Reading all of this, I would imagine having a few more wired IO ports, as well as an I2C bus would go a great deal. For those who really want to go bluetooth (including myself) are there not I2C/bluetooth devices on the market? One problem I (...) (21 years ago, 31-May-05, to lugnet.robotics)
 
  Re: Lego controller
 
On Tue, May 31, 2005 11:17 am, Martijn Boogaarts said: (...) Ok, I'm not sure what you're in favor of, here. :) First, with the current setup, don't you have to leave the front of the RCX clear, so the IR can flow in? And, if the RCX used a wire, (...) (21 years ago, 31-May-05, to lugnet.robotics)
 
  Re: Lego controller
 
Steve (and others) Read in-between the lines for comments (...) Imagine you have multiple RCX units build in a large model then it is convenient to not have to leave a place open for the connector to program it. During a class session I found that (...) (21 years ago, 31-May-05, to lugnet.robotics, FTX)
 
  Re: New Lego controller
 
(...) Gabe, How do the motor controllers work? It's hard to see from your web page, but I don't see a motor driver, or anything. Are you running the motors directly off the 5v chip? Steve (21 years ago, 31-May-05, to lugnet.robotics)
 
  Re: Lego controller
 
(...) The IR wireless connection served in many of our advanced projects. This just gives you great possibilities with mobile robots. (...) Bluetooth is a very versatile RF-communication that could allow real flexible networking for multi-agent (...) (21 years ago, 31-May-05, to lugnet.robotics)
 
  Lego controller
 
Martijn, Most of these are pretty clear. Of course, this discussion comes up every few months. But I have a couple questions... On Tue, May 31, 2005 5:44 am, Martijn Boogaarts said: (...) Do many people use the IR as a way to communicate between a (...) (21 years ago, 31-May-05, to lugnet.robotics)
 
  Re: New Lego controller
 
(...) Hi All, yes the rumors are strong... Last AFOL Mindstorms Competition (in Billund, LEGO home :) ), the Director of the MS division came and spoke to all the competitors (MS gurus) and asked them: "What do you think is important in a new RCX ?" (...) (21 years ago, 31-May-05, to lugnet.robotics, FTX)
 
  Re: New Lego controller
 
(...) Hi Dan, I seem to remember discussing this before. I agree this would be perfect. In terms of software, the system could start out as a simple one module system, and use an interface like robolab or RCX code to start newbies off. When a new (...) (21 years ago, 31-May-05, to lugnet.robotics)
 
  Re: New Lego controller
 
I've heard rumors Lego may be planning a new Mindstorms product. IMNSHO something like this would be perfect. Smaller units, more modularity, easy connectivity between brains. It fits perfectly into the Lego paradigm, and the technology is finally (...) (21 years ago, 31-May-05, to lugnet.robotics)  

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR