To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 17445
17444  |  17446
Subject: 
Re: Erroded axles
Newsgroups: 
lugnet.technic, lugnet.robotics
Date: 
Tue, 12 Mar 2002 11:44:03 GMT
Viewed: 
244 times
  
In lugnet.technic, Thomas Avery writes:
In lugnet.technic, Fredrik Glöckner writes:
<snip>
I don't think there is any way to avoid this problem.  Perhaps there
exist some kind of synthetic grease, which can be used to reduce the
friction?  If so, this could be the solution to your problem.  But keep
in mind that the grease will be quite messy, and you need to make sure
that it is not a kind of grease which ruins the ABS material out of
which LEGO bricks are made.  Most kinds of grease are probably
incopatible with plastic materials.

Lubrication has been discussed quite a bit before. Be sure to check out
"lubrication" under the Popular Subjects and FAQ section on the Technic
front page:
http://www.lugnet.com/technic/lube

TJ

Yes, i did it before posting the message. It is of no use for me, front axle
is too low - too small ground clearance, every lubrication i tried catched
dust and made things much worse. I didn't tried teflon (?tephlone?) as
lubricatin yet.



Message has 2 Replies:
  Re: Erroded axles
 
(...) I think that's just an inherent problem with lubricating parts. I don't think there is an easy way around it, unless we operate our models in a very clean environment. But even then it's hard to keep everything clean. (...) Have a look though (...) (23 years ago, 12-Mar-02, to lugnet.technic, lugnet.robotics)
  Re: Erroded axles
 
Why not try spray graphite ? It's dry so dust won't stick : ) Robert Seifert <seifrob@hotmail.com> wrote in message news:Gsuz9F.GDE@lugnet.com... (...) axle (...) (23 years ago, 13-Mar-02, to lugnet.technic, lugnet.robotics)

Message is in Reply To:
  Re: Erroded axles
 
In lugnet.technic, Fredrik Glöckner writes: <snip> (...) Lubrication has been discussed quite a bit before. Be sure to check out "lubrication" under the Popular Subjects and FAQ section on the Technic front page: (URL) (23 years ago, 11-Mar-02, to lugnet.technic, lugnet.robotics)

17 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR