 | | Re: Racing Line Follower
|
|
In Creative Projects I make recommendations on line followers. One of them is to add a touch sensor that you can use as a trigger to grab the light levels of the line and the surface and store them in memory. Then you can use the average of those (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Delayed BrickBots contest results
|
|
Hi Folks, Two BrickBots.Com contests ended last week, and here is a rundown of the results. First, the Top Spinning Challenge - Get as many tops spinning simultaneously for as long as possible. (URL) Tip Top Top Tipper Score: 27 points! (URL) (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: List software?
|
|
(...) In my experience, one wants to reply to the list more often than just to the sender. Perhaps I'm wrong. In any case, anyone wishing to just reply to the sender would remove the list address from their outgoing message, and fill in the sender's (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: List software?
|
|
(...) No no no no no no no!!!! I ABSOLUTELY hate mailing lists that do that; it makes it near impossible to reply just to the sender. --Ken (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
(...) HeHeHe !!! :-) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
I think I would take your stop watch back to the jeweler. -- Bob Fay rfay@we.mediaone.net (URL) Fasting" <lego-robotics@crynwr.com> wrote in message news:3.0.6.32.200104...line.no... (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | List software?
|
|
What software runs this mailing list? I ask because I'd like to find out what it would take to get it to put the ML address into messages as the Reply-To address. I run a couple of lists myself (using 7-line SED scripts) and it seems like this (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Yes, this is the result I discovered this weekend. My conclusion is that setting the sensor to raw mode does not fully remove the light produced by the LED, and detrimentally impacts the sensor performance. I think my next approach is to try (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Racing Line Follower
|
|
Hello I've built a line follower which is quite fast (approx 4 secs per lap on the testpad). It consists of two motors, each powering a 2/3 geared large wheel. Two light sensors are attached to the front pivot wheel. The distance between the sensors (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: David Schilling
|
|
Oh I see. thanx....good luck! (...) (24 years ago, 2-Apr-01, to lugnet.robotics, lugnet.org.us.smart)
|
