To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *24034 (-20)
  RE: NQC versus Lego RCX Code Speed
 
(...) No, the Lego GUI software and NQC both produce code for the same target -- a simple interpreted virtual machine implemented in the firmware. I have never looked at the code produced by the Lego GUI, but I can't imagine it would be that much (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Re: Miniboard download random failures
 
(...) "expected (...) James, Yes, I am running from a DOS window in W9X. Do I have to boot to DOS mode to correct for this? Uhm, I'm a Mac person, so, have patience, how does one boot to DOS instead of Win95? thanks, DLC (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  RE: NQC versus Lego RCX Code Speed
 
Wilcox, Doug (11:04 AM 10.05.2000) wrote: >Hmm. This question seems to have gone the way of my PC-->IR Tower cable >question. > >Let me try to get at the point that most interests me--what is the >difference, at the RCX level, between programs coded (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  RE: NQC versus Lego RCX Code Speed
 
Hmm. This question seems to have gone the way of my PC-->IR Tower cable question. Let me try to get at the point that most interests me--what is the difference, at the RCX level, between programs coded in NQC and programs coded in RCX Code. Is the (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Re: Miniboard download random failures
 
(...) Are you running DLM from a dos window in Win9x? I've had this problem but it usually stops when I run it in DOS. Just a thought. -Jim Munro <jimmn@xnet.com> (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  Freeware ICC11 and bad iasm11.exe?
 
Me again, I just got the ICC11 freeware from the Miniboard site and installed it, moving the crt.s over as it says to do in the docs, etc. I tried to compile the test compile of icc11 dhry.c printf.c and got a LOT of "phasing" errors, whatever that (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  Miniboard download random failures
 
Hello, I just finished building a Miniboard using the HC811E2 processor. After swapping the Rx and Tx lines on my serial cable the download and reset switch do as the manual says. However, when I use dlm to download a program the bootstrap section (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  Cybermaster on sale
 
Yesterday I saw that the Cybermaster is on sale at the Bart Smit toy shops in the Netherlands, now only fl. 169,- (approx US$ 70) instead of fl. 449,-. I bought just one... Emile. (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Re: The datalog
 
(...) Series of measurements. I've used it to measure light sensor values while doing a 360 degree turn next to a candle (disappointing, the candle made hardly a dent), and to measure raw values for touch sensors while pushing them slowly, 1/100mm (...) (26 years ago, 5-Oct-00, to lugnet.robotics.rcx.nqc)
 
  Re: Remote dead, what to do?
 
(...) Are you sure it is the remote? Maybe your RCX forgot its firmware, then the remote won't work. Jürgen (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Re: A neat idea for touch sensors
 
(...) That probably was me ((URL) That required a lot of Lego wires, put together in funny (...) I used five wires for convenience, since I have enough of them. But you can get by with just three wires if you connect them directly to the sensors and (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Remote dead, what to do?
 
My remote control suddenly stopped working yesterday, and I immediately replaced the batteries, but that does not appear to have been the problem. What is the failure mode of these devices? Can the ir "bulb" burn out? If so, can it be replaced? Is (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  legOS doesn't work under NT?
 
I've been using legOS for Windows (Vamos-Wentworth's distribution) both on Windows 95 and Windows 98. Due to some reasons, I'll have to use a NT computer from now on (I'm the administrator). I installed everything, even the long filename support (...) (26 years ago, 5-Oct-00, to lugnet.robotics.rcx.legos)
 
  Re: A neat idea for touch sensors
 
Hi Rob, (...) Yes. But by looking carefully at the connectors it's not too hard to figure out how to do it. (...) I think it is just that in most cases parallel connections are needed, and you got to decide between the two possibilities if you want (...) (26 years ago, 5-Oct-00, to lugnet.robotics)
 
  Re: Is Extreme Creatures Good? (WAS: Re: US S@H Specials, Sep 20 - Sep 26, 2000)
 
(...) i'll (...) Not in my opinion, just a random collection of additional parts. There is an inventory at: (URL) I didn't buy the set, so maybe owners of the set would have a contrary opinion. Kerry (26 years ago, 5-Oct-00, to lugnet.market.shopping, lugnet.robotics.rcx, lugnet.robotics, lugnet.technic)
 
  serial communication
 
Hi.. I am also facing problem in serial communications. My problem is that I am trying to use the handyboard to drive a modem. I have used a cross-serial cable to connect my handyboard's external serial board to a modem. But whenever I run my app, (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  R: communication via serial port
 
Using java and comm API ? ----- Original Message ----- From: Ray Tang <raytang_1@hotmail.com> To: <handyboard@media.mit.edu> Sent: Thursday, October 05, 2000 4:49 AM Subject: communication via serial port (...) and (...) the (...) a (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
 
  Re: The datalog
 
(...) If only the RCX could read it's own data... Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 5-Oct-00, to lugnet.robotics.rcx.nqc)
 
  ------( Terms of use for lugnet.com )------
 
TERMS OF USE FOR LUGNET.COM OVERVIEW AND DEFINITIONS lugnet.com ("LUGNET") is a privately owned Internet site designed and run primarily for the benefit of those who enjoy building with, discussing, collecting, buying & selling, trading, and (...) (26 years ago, 5-Oct-00, to lugnet.robotics.vc)
 
  ------( Welcome to lugnet.robotics.vc )------
 
Welcome to lugnet.robotics.vc, a LUGNET discussion group. CHARTER/PURPOSE: lugnet.robotics.vc (group): Focused discussion group for LEGO® MINDSTORMS™ Vision Command™ and related components: the LEGO Cam, vision recognition, algorithms, software (...) (26 years ago, 5-Oct-00, to lugnet.robotics.vc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR