Subject:
|
Re: Miniboard download random failures
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 5 Oct 2000 14:57:12 GMT
|
Viewed:
|
1108 times
|
| |
|
|
> baud download runs and will fail in random locations with "read xx", "expected
> YY". The failure occurs at random times with random values. What should I
> make of this? Once I was able to download all of HEXMON successfully, but
> while running Hyperterm I never got the ">" when reset was pressed on the
> board so I don't think it really worked. Now I can't even get a short
> program to go more than about 64 bytes in before freezing or erroring out.
Are you running DLM from a dos window in Win9x? I've had this problem but
it usually stops when I run it in DOS.
Just a thought.
-Jim Munro
<jimmn@xnet.com>
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Miniboard download random failures
|
| Hello, I just finished building a Miniboard using the HC811E2 processor. After swapping the Rx and Tx lines on my serial cable the download and reset switch do as the manual says. However, when I use dlm to download a program the bootstrap section (...) (24 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
