Subject:
|
Re: Badly designed common Lego parts
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sat, 12 Apr 2003 04:40:05 GMT
|
Viewed:
|
1363 times
|
| |
|
|
In lugnet.general, Stéphane Simard writes:
> 1) Headlight 1x1 brick.
> http://www.peeron.com/inv/parts/4070
> I wish I had a dime everytime I buy some used headlight bricks and there's a
> crack in the front center of the base...
>
> 2) Standard 3-stud-diameter wheel.
> http://www.peeron.com/inv/parts/3482
> Widely used in large Town vehicles such as buses, and almost all Technic
> airplanes, helicopters and aircraft use those as landing gear. Not only are
> those things likely to snap at any time should you remove them from their
> tyres, but Lego's been producing them for 25+ years now and have never
> improved them.
>
> 3) Standard technic connector.
> http://www.peeron.com/inv/parts/3651
> Inevitable cracks at the base. Discontinued by Lego, replaced by the much
> sturdier
> http://www.peeron.com/inv/parts/32013
> at the loss of "piston" studs.
>
> Any similar experiences?
>
> Any more badly designed parts anyone is willing to list?
I had problems with all these parts as well. Add to that the original
classic space helmet. The chin strap was too thin, and they would
frequently snap in half.
Adrian
--
http://www.brickfrenzy.com
|
|
Message is in Reply To:
 | | Badly designed common Lego parts
|
| 1) Headlight 1x1 brick. (URL) wish I had a dime everytime I buy some used headlight bricks and there's a crack in the front center of the base... 2) Standard 3-stud-diameter wheel. (URL) used in large Town vehicles such as buses, and almost all (...) (24 years ago, 10-Apr-03, to lugnet.general)
|
9 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
