Subject:
|
Re: wishing upon a star
|
Newsgroups:
|
lugnet.db.brictionary
|
Date:
|
Thu, 26 Aug 1999 22:07:34 GMT
|
Viewed:
|
2459 times
|
| |
|
|
In lugnet.db.brictionary, Tamyra Teed writes:
> For anyone that might not know this, Mold numbers are not unique. A
> mold is setup for all the parts and it makes more than 1 piece at a
> time. If you take the 2x4 brick mold, it could possibly do 8 bricks at a
> time which means each brick in the mold has a number 1-8. This is for
> quality control measures, if they continually find a bad brick in each
> injection they can check the number on the brick and they'll know if the
> mold needs some work, or if they should program the machine to not fill
> that section.. (if this isn't clear it's because I've only been up 5
> mins and haven't even cracked my first dew yet)
It sounds like you're talking about the mold quality control numbers.
On most LEGO parts that a large enough concealed surface, you find three
numbers -- two vary from part to part for the reasons you describe. These are
usually one or two digits long. The third is usually 4 or 5 digits long and is
the "unique" number people have been talking about.
As others in this thread have mentioned, this "unique" number sometimes changes
too, usually due to an engineering design change.
If the available surface is smaller, the engineers usually sacrifice the part
number in favor of the quality control numbers.
- Robert Munafo http://www.mrob.com/
LEGO: TC+++(8480) SW++ #+ S-- LS++ Hsp M+ A@ LM++ YB64m IC13
|
|
Message is in Reply To:
 | | Re: wishing upon a star
|
| (...) For anyone that might not know this, Mold numbers are not unique. A mold is setup for all the parts and it makes more than 1 piece at a time. If you take the 2x4 brick mold, it could possibly do 8 bricks at a time which means each brick in the (...) (25 years ago, 26-Aug-99, to lugnet.db.brictionary)
|
22 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
