Subject:
|
Re: L3P and/or L3PAO
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Wed, 19 Jun 2002 09:36:21 GMT
|
Viewed:
|
564 times
|
| |
|
|
In lugnet.cad.dev, Ahui Herrera writes:
> Can MLCAD or some other applciation take out ALL the steps from
> a .ldr file? This would be a quick fix to the problem.
Would that solve all your problems?
You always want to ignore steps in submodels when rendering main model?
Do you render submodels separately for BI ?
/Lars
|
|
Message has 1 Reply:
 | | Re: L3P and/or L3PAO
|
| (...) It would be a solution. Basically in the end I would have 2 set of files: Set 1: for distribution model.mpd (which is made of) complete.ldr submodel1.ldr submodel2.ldr Note that ALL of these files would have their steps IN THEM! So that a user (...) (22 years ago, 19-Jun-02, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: L3P and/or L3PAO
|
| (...) I start off by making one ldraw model first. Usually it has no steps and parts are in NO particular order. Once I got the model done, I go back and begin to figure out what sections should be sub-models if any. At this point I begin to build (...) (22 years ago, 19-Jun-02, to lugnet.cad.dev)
|
13 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
