 | | Re: VOTING now working
|
|
BTW, does everyone use the Abstain option? I will generally abstain on any piece I don't have, unless there are obvious problems with a part. Steve (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) Ah. That clears it up. I'll dig up one of these pieces when I get home, to be sure I understand. Steve (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
(...) about (...) part (...) That still wouldn't make it possible in Ldraw to (I)nsert a new piece, change the (P)art number, then type the part number of the part which is in your hand, and have it inserted. Multi-part parts are a problem, of (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) I probably did a bad job at explaining what is wrong. Looking at the 2853 part with the grey axle pointing towards you, you'll see a round hole in the grey surface next to the axle which sticks out. (This hole is rectangular on some versions (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | RE: part: panel 1 x 2 x 1 with black grille pattern
|
|
(...) I think it is a bad tendency if we are going to speculate in specific rendering programs: adding extra drawing commands, so that at least some of them will show under certain circumstances. Hints for specific rendering techniques should be (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts wanted
|
|
(...) I'm not following the problem, here. It may because I don't have one of these pieces to look at, but I'm not seeing what shows through, and if something did show through, how having rounded-end axles would help. I modified your code to use a (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: VOTING now working
|
|
Terry, I have a suggestion. I just voted like a senator again :-, abstaining from about half the votes. I don't know what the typical vote turnout is like, but in my method of voting, it would be pretty cool if all the votes default to "Abstain". As (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | RE: part: panel 1 x 2 x 1 with black grille pattern [DAT]
|
|
(...) Actually I sent Terry an update to 3004P06.DAT some weeks ago using quads rather than rect.dat. It is going to be in the next parts update. Also mine stripes are more accurate when you put two bricks on top of each other with one of them (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Steve Bliss wrote in message <36daaf01.8075147@lu...et.com>... (...) I'd say you're most certainly right here since their numbering system would be for premarket tracking and not as we would use it in the post-market. Does anyone know if TLG sells (...) (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: parts i plan to do
|
|
(...) But don't dump all the parts into the parts tracker -- wait until you are reasonably close to working on a part before adding it. Steve (26 years ago, 1-Mar-99, to lugnet.cad.dev)
|
