| |
> In that case, I shall rescan without the head, from more angles, and with finer
> settings - I was trying (unsuccessfully) to try and limit the polygon count by
> scanning in lower resolution, but if you're using other software to downsample
> afterwards then that isn't necessary.
Yes, better have more resolution at the beginning. In many cases I downsample
differently on different sections of parts. Eg. for Dobby's head
(http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/43745.dat) I first reduced
polygon count to a high value, then reduced again in all areas except important
areas: eyes and mouth.
> Can your software read .SCN files? That is the native file format output by the
> scanner; if you can read them then I can skip the STL translation.
Unfortunately no, the only serious 3D software I use is Meshlab, here are the
supported formats:
http://meshlab.sourceforge.net/wiki/index.php/Supported_Formats
A photo of inside of part (showing stud connection) would be appreciated too!
Philo
|
|
Message is in Reply To:
 | | Re: 3D laser scanning
|
| (...) Thanks, Philo! In that case, I shall rescan without the head, from more angles, and with finer settings - I was trying (unsuccessfully) to try and limit the polygon count by scanning in lower resolution, but if you're using other software to (...) (16 years ago, 23-Mar-11, to lugnet.cad, lugnet.cad.dat.parts)
|
31 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
