Subject:
|
Re: Two versions of the "Technic Axle Joiner"
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 2 Feb 1999 22:23:12 GMT
|
Viewed:
|
1960 times
|
| |
|
|
Fredrik Glöckner wrote:
> On the other hand, I discovered yesterday that I have _two_ versions of
> the "Technic Axle Joiner"; one which is the way Karim pointed out, and
> has the number 6538 molded into it, and one which is the way Jessiman
> drew it, but without any number on it.
Hmmm I didn't know about that part... now i have to go back and sort out any old
ones i have :)
> Anyway, I also wanted to say that if the part 6538.DAT gets fixed, the
> exterior should be rotated, not the interior. This is because more
> people will have used it to connect to an axle than between four studs,
> thus the new version will conflict less with existing drawings that way.
> Or so I guess, at least.
This is a very good point! thanks!
--Karim
|
|
Message has 1 Reply:
 | | Re: Two versions of the "Technic Axle Joiner"
|
| (...) :-) I just noticed, BTW, that the one I have which is the way Jessiman drew it, is from the 8857 Street Chopper. (URL) the oldest Technic set I have with an axle joiner, so I guess all sets from 1993 and backwards have this version. The 8880 (...) (28 years ago, 3-Feb-99, to lugnet.cad)
|
Message is in Reply To:
| | Two versions of the "Technic Axle Joiner"
|
| Not long ago, Karim Nassar posted a note on the L-CAD mailing list saying that the interior of the "6538 Technic Axle Joiner" was rotated 45° comparing with the original piece. This is true. On the other hand, I discovered yesterday that I have (...) (28 years ago, 2-Feb-99, to lugnet.cad)
|
14 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
