Subject:
|
Re: Transparent parts (small)
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 9 Jun 2005 06:50:28 GMT
|
Viewed:
|
1120 times
|
| |
|
|
In lugnet.cad, Jaco van der Molen wrote:
> In lugnet.cad, Travis Cobbs wrote:
> > In lugnet.cad, Travis Cobbs wrote:
> > > (I know you said you prefer to use LDGLite as the renderer, and LDView is
> > > certainly slower than LDGLite, but LDView is a whole lot faster than POV-Ray. I
> > > seem to remember Don commenting in the past that sorted blended transparency
> > > wasn't supported in LDGLite. I suppose that could have changed, though.)
> >
> > For reference, here's a sample that includes an LDView-rendered transparent
> > part:
> >
> > http://www.halibut.com/~tcobbs/ldraw/private/car_0_06_parts.PNG
>
> Using what settings can I achieve this?
> I cannot seem to get this result.
I exported my settings from regedit, and stored them here:
http://www.halibut.com/~tcobbs/ldraw/private/LDView-LPub.reg
The above file contains just the LPub preference set settings from my LDView.
If you download it and double-click on the file, you will be asked if you want
to import the settings into regedit. If you click yes, you'll get the current
settings I have in my LPub preference set in LDView. They should produce an
image comparable to the one above (as long as you're using the version of LDView
I posted a link to three message up).
--Travis
|
|
Message has 1 Reply:
Message is in Reply To:
14 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
