Subject:
|
Re: 60 degree problem
|
Newsgroups:
|
lugnet.build
|
Date:
|
Fri, 15 Jan 1999 06:25:02 GMT
|
Reply-To:
|
LPIEN@stopspamIWANTNOSPAM.CTP.COM
|
Viewed:
|
1169 times
|
| |
|
|
Todd Lehman wrote:
>
> Larry Pieniazek <lar@voyager.net> writes:
> > Whoops, this is not what I thought. Typing too fast. If this is 2
> > plates, one with 2 fingers and one with 3 fingers on the end, which
> > coupled together take the same space as a 1x5 plate would, these are
> > "two finger" and "three finger" hinges. AucZILLA calls these
> >
> > 1x2 plate with 2 finger hinge
> > 1x2 plate with 3 finger hinge
> >
> > respectively.
>
> I thought they were called
>
> 1x2 Plate w/ 2 Hinge Fingers
> 1x2 Plate w/ 3 Hinge Fingers
>
> there...
Ya, Ya, Ya... I was typing fast and working from memory. You're right. I
was close enough, though.
++Lar (in Walnut IA!)
|
|
Message is in Reply To:
 | | Re: 60 degree problem
|
| (...) I thought they were called 1x2 Plate w/ 2 Hinge Fingers 1x2 Plate w/ 3 Hinge Fingers there... If something is a 3-finger hinge, wouldn't it mean that it's a [full] hinge that has 3 fingers [total]? Say, speaking of which, Joshua once told me (...) (25 years ago, 14-Jan-99, to lugnet.build)
|
32 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
