Subject:
|
Re: 60 degree problem
|
Newsgroups:
|
lugnet.build
|
Date:
|
Wed, 13 Jan 1999 17:48:27 GMT
|
Viewed:
|
1039 times
|
| |
|
|
James Brown writes:
> I've got a design problem that I'm having a hard time working around - • normally
> I'd just drop the design, but this one has such great possibilities I'd hate • to
> have to do that.
>
> I'm building an articulated 3-claw foot, based off of 1x4/2x2 hinge plates as • a
> center-point, arranged so:
>
> ||
> //\\
Ok, it's fairly obvious I wasn't clear enough (I can't even figure out what I
meant <grin>) so here is a second attempt. The part I am using as the major
component of my foot design is the (aucZILLA designation)1x4/2x2 corner-connect
plate hinges. Using 1, 2, and 3 to represent stud locations from the three
hinge-plates, I will attempt a clearer ASCII drawing. 'x' represents the
equilateral triangle formed by the three sides - hence the original title of my
post. The '/' are there because LUGnet tried to interpret this as a .dat file
without them.
/ 1 3 3 2
/ 1 3 3 2
/ x
/ 1 2
/ 1 2
Essentially, a perfect 120 "y".
That still doesn't quite get the angles right, but I think it gets the point
across. I have connected the hinges together with 2x2 plates over each of the
three 'sides' so there is no freedom of motion in the hinges (alternating these
layers makes for a very solid structure), and am trying to figure out a way to
anchor a single larger plate to all three orientations.
My original question still stands - does anyone have a solution for me?
|
|
Message has 2 Replies:
 | | Re: 60 degree problem
|
| (...) connect (...) my (...) these (...) Have you tried a Technic 3 blade rotor? It's not *quite* what you are trying to build, but I think it should be workable. Duane (26 years ago, 13-Jan-99, to lugnet.build)
| | | Re: 60 degree problem
|
| (...) (macaroni) (...) That's amazing! For anyone who didn't understand Rob, I've posted the foot to lugnet.cad.dat. --Bram Bram Lambrecht / o o \ BramL@juno.com ---...---oooo-----(_...o---...--- WWW: (URL) (26 years ago, 14-Jan-99, to lugnet.build)
|
Message is in Reply To:
| | 60 degree problem
|
| I've got a design problem that I'm having a hard time working around - normally I'd just drop the design, but this one has such great possibilities I'd hate to have to do that. I'm building an articulated 3-claw foot, based off of 1x4/2x2 hinge (...) (26 years ago, 12-Jan-99, to lugnet.build)
|
32 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
