 | | Re: Question about point/switch modifications.
|
|
(...) OK thanks - I wasn't looking closely enough. Do you have any more pictures from the procedure? Although I presume you did the same to re-attach the bits as you did on the new procedure. I gather you're cutting the branch off immediately after (...) (20 years ago, 8-Apr-04, to lugnet.trains)
|
| |
| | Re: Question about point/switch modifications.
|
|
(...) I'm not that good on the first cut--precision doesn't quite work for me. I lopped off the end of the switch just after the third tie (third would be including the half tie at the end), I cut up a curved track just on the outside of the center (...) (20 years ago, 8-Apr-04, to lugnet.trains, FTX)
|
| |
| | Re: Question about point/switch modifications.
|
|
(...) That's what's put me off so far. I don't have a very steady hand and a dremel goes at minimum of 10,000rpm. I'd be likely to shatter the disc, slice the parts in the wrong places or chop into my hand! At least the table saw you showed had a (...) (20 years ago, 8-Apr-04, to lugnet.trains, FTX)
|
| |
| | Re: Question about point/switch modifications.
|
|
(...) There are other options available. Rotary tools come in three standard groupings: single speed (on/off), multi-speed (2 or more fixed speeds), and variable speed (low, high, and everything between). Mine is a Craftsman-label manufactured by (...) (20 years ago, 8-Apr-04, to lugnet.trains, FTX)
|
| |
| | Re: Question about point/switch modifications.
|
|
(...) [snipped] My first couple track modifications, I used a scroll saw. This works very good for the ABS... but poorly for the metal rail. Later, I learned that using a cutting disc/dremel on the metal rail was much easier. I then run the track (...) (20 years ago, 9-Apr-04, to lugnet.trains)
|
| |
| | Re: Question about point/switch modifications.
|
|
I've sold a few of my custom crossovers on eBay so I thought I'd chime in about cutting tracks and other track mods. I always remove the rails before cutting and my cutting is done with a single edge razor blade, making a rough cut first, then (...) (20 years ago, 9-Apr-04, to lugnet.trains)
|
| |
| | Re: Question about point/switch modifications.
|
|
My observations: 1. Dremel disks break. Get a good pair of Safety Glasses _AND USE THEM_. How do I mod track? Jewelers saw, Dremel, File, 5 min epoxie, small soldering iron, 2x6 lego brick, 2x4 lego plate, solder & rosin flux. Take saw. Cut plastic (...) (20 years ago, 10-Apr-04, to lugnet.trains)
|
