Subject:
|
Re: Finally...
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Sat, 24 Nov 2001 01:10:08 GMT
|
Viewed:
|
1201 times
|
| |
|
|
> I was laying awake last night wondering what 125ma would power when I
> suddenly released that it should power a relay. Can you take power
> directly from the track, run it though a AC~DC converter and use that to
> power motors? (I'd run it though a 9 volt power reg package too)
You could also power a power transistor with it :) That'd take up less room...
I'm not too sure as to the best approach. Perhaps a friendly Email to
digitrax would get a answer as to possible approaches?
James
|
|
Message is in Reply To:
 | | Re: Finally...
|
| (...) That's good! For a while there I thought I had no control over my lights. But of course no modeler would put up with that! (...) Yes. But, from what I can glean from the web site, the DN142 is the same size so it will work. I was laying awake (...) (23 years ago, 23-Nov-01, to lugnet.trains)
|
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
