To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 9188
  Re: Props for Hovercraft
 
Yes, I had tried that. I was unable to prevent all the rotation at the friction pin, and even a small amount of movement there caused significant wobble/binding. Mark Haye "Ross Crawford" <rcrawford@csi.com> wrote in message (...) (22 years ago, 7-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
How about inserting the 24T gear into half a large turntable, and securing the other end of the turntable using axles. I know this gets very large where you don't want to get large, but it might provide stability in ways the other solutions do not. (...) (22 years ago, 7-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
(...) Well I did a little test, heres the pics: (URL) that the propeller shaft is cylindrical, not "x" axle-shape, so friction is much greater than standard axle. It worked reasonably well, even with no lubrication and old batteries. I reckon with (...) (22 years ago, 7-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
(...) Nice design. Oh man, the design of the 24t gear at the back of this propeler is realy lame. That whole part is very un-legoish. 1) Perhaps you could use the old friction connector instead of the new one: i.e. part 4459 instead of part 2780. (...) (22 years ago, 8-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
You guys are bound and determined to spend my whole weekend tinkering on this, aren't you? ;-) I reproduced Ross's setup using a gray peg, a black friction peg, and an old black friction peg. I still get what I consider pretty poor performance (with (...) (22 years ago, 8-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
"Mark Haye" <markhaye@netzero.net> wrote in message news:HA05tr.EJx@lugnet.com... (...) Offcourse, we dont give up before we have succeeded :) I'm just been bitten of this LEGO-flying machine virus .... (...) old (...) hit (...) Whatever speed you (...) (22 years ago, 8-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
Here are photos of my most effective props until now. (URL) Steinnes (URL) (22 years ago, 9-Feb-03, to lugnet.technic)
 
  Re: Props for Hovercraft
 
(...) friction pin, (...) Perhaps the z24-sandwich can be wrapped with conveyor chain links? /Tobbe (22 years ago, 10-Feb-03, to lugnet.technic)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR