To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 856
855  |  857
Subject: 
Re: Does anyone else's Pit Droid not "pop" up properly?
Newsgroups: 
lugnet.technic, lugnet.general
Date: 
Mon, 17 Jan 2000 21:12:07 GMT
Viewed: 
1153 times
  
Mine --- er, "my daughter's" (it was her birthday gift after all :-), stands
just fine,
with the heel pointing down.  In fact, with the heel flat, he would probably
topple
backward.  He really is quite stable standing.

On the other hand, regarding the "pop" my daughter got quite upset that he
only "pops"
properly when held up.  I had to take her to the movie again (gosh, I hated
that :-) to
demonstrate that the most obvious popping happens only when Jar-Jar is
holding the
droid...  But I admit, it ticked me off too -- I thought it should pop from
scrunched to
standing (with a possible topple afterward) but it doesn't, and the
mechanics of
the folding make that essentially impossible...

-Peter


"Jonathan Little" <piano254@aol.com> wrote in message
news:FoEJz9.87D@lugnet.com...
In lugnet.technic, Paul Davidson writes:
The heels point downwards.  I double-checked this when I was assembling • it,
since it seemed awkward.  But with both legs, mine stands very well.  I • can
even bump him around on my desk, and he slides instead of falling over.

--


Paul Davidson

I realize that the instructions have the green "heel" part pointing down, • but
mine would not stand like that. I keep it folded up on the shelf because • it
won't stand. When I made the change that was suggested earlier about • pointing
the green "heel" backwards, it stood for the first time since I got it. • Maybe
I made some other mistake that is causing him to fall forward when the • "heel"
is pointing down. When I get a spare hour, I'm going to take him apart and
double check to make sure I didn't do anything wrong.

-Jonathan



Message has 1 Reply:
  Re: Does anyone else's Pit Droid not "pop" up properly?
 
If you look at the design, there is a half-pin around the ancle or calf that keeps the thigh from over extending. Mine (at first) had a problem standing, with the knee joint being slightly out and the half pin did not prevent it from over rotating. (...) (24 years ago, 17-Jan-00, to lugnet.technic, lugnet.general)

Message is in Reply To:
  Re: Does anyone else's Pit Droid not "pop" up properly?
 
(...) I realize that the instructions have the green "heel" part pointing down, but mine would not stand like that. I keep it folded up on the shelf because it won't stand. When I made the change that was suggested earlier about pointing the green (...) (24 years ago, 16-Jan-00, to lugnet.technic, lugnet.general)

14 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR