Subject:
|
Re: 120 degree connector
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 13 Jun 2001 19:42:33 GMT
|
Viewed:
|
1714 times
|
| |
|
|
In lugnet.technic, Chris Phillips writes:
> Couldn't you use an equilateral triangle to construct a 120-degree angle?
> Like the top picture that Thomas posted, but either Technic beam extends two
> holes past the point where the two beams pivot. Then a simple 3-hole
> 1/2-wide connector (sorry, I don't remember the real name of this piece, but
> it is flat, oval, and 3 pinholes long) connects the end hole of the
> overhanging beam to the third hole in on the other beam. You could use
> longer connectors as well, as long as you extend the overhang to match.
>
> Am I making any sense?
Yep, perfect sense. Try it again:
http://tanyatj.home.texas.net/tjscreations/quick_pics/
T. J.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: 120 degree connector
|
| (...) Couldn't you use an equilateral triangle to construct a 120-degree angle? Like the top picture that Thomas posted, but either Technic beam extends two holes past the point where the two beams pivot. Then a simple 3-hole 1/2-wide connector (...) (25 years ago, 13-Jun-01, to lugnet.technic)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
