Subject:
|
Re: Swan Firmware
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Sun, 6 Feb 2005 17:18:14 GMT
|
Viewed:
|
6353 times
|
| |
|
|
Okay, okay, bad form responding to my own post. I got the new firmware on
my RCX, downloaded the latest version of BricxCC, and NQC. But I can't
figure out how to use this SetUserDisplay command? I want to show a
variable on the display. I have no idea how to do that?
Also the delay thing. If I just put in Wait (1) will it now wait 1/1000
instead of 1/100?
Iain
|
|
Message has 1 Reply:
 | | Re: Swan Firmware
|
| (...) Having downloaded a copy of swan_test.zip which contains the latest test release of BricxCC and NQC you can use nearly all the new and enhanced features in the Swan firmware. You can view the "official" API built into NQC by executing the (...) (20 years ago, 6-Feb-05, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | Re: Swan Firmware
|
| (...) I feel so awful asking this, becuase I'm sure it must have been covered somewhere before - I'm not very good at understanding quite how everything works (API's and includes and so forth - no idea what that stuff is!). But here's my question: (...) (20 years ago, 6-Feb-05, to lugnet.robotics.rcx.nqc)
|
23 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
