| |
In lugnet.robotics.handyboard, Fred G. Martin writes:
> Info on doing this is at http://handyboard.com/sensors/ . The
> male strip header is 929400-01-36-ND from Digikey.
>
> Fred
Thanks, I thought there might be a special connector but I see now that its
a standard enough connector.
Another question: How can I get the handy board to read from the lego
rotation sensor and the lego light sensor? I can get the touch sensor to
work no problem but Im having difficulty with the others.
Thanks, Brendan
|
|
Message has 2 Replies:
 | | Re: Sensor Connector
|
| The LEGO shaft encoder and light sensor are active sensors that need a special circuit. The Expansion Board for the HB provides this ckt and the requisite drivers. Your simplest path to using these with the HB is to get an Exp Bd. Barring that, you (...) (23 years ago, 7-Feb-02, to lugnet.robotics.handyboard)
| | | Interactive C
|
| (Perhaps this isn't the right place to ask questions about I.C. but it is related to the handy board so I will continue) I am trying to write a program that uses the lego sensors and multiplies them by constants that are floats. The expansion board (...) (23 years ago, 25-Feb-02, to lugnet.robotics.handyboard)
|
Message is in Reply To:
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
