| |
In lugnet.robotics.handyboard, Sam Weiss writes:
> I've bought some lego electric plates (part 5037) from lego.com, and they
> seem to be withstanding the heat of a soldering iorn quite well (that was my
> fear... that I would turn them into bubbling messes). Actually they're
> holding up better than the male header pins I'm using to connect them to the
> HB (mybe I need to buy better ones). Here's what I've done so far:
Actually what I was looking for was how to make the male header pins to
connect to the HB. Is there anywhere to buy them or how did you make them.
Thanks for your answer,
brendan
|
|
Message has 1 Reply:
 | | Re: Sensor Connector
|
| (...) Oh, that's easy. Just check out your local electronics store. I don't know if there is a Fry's Electronics in your area, but they have them. Radio Shack? I don't know, but I would assume anyone who sells electronic components would have them. (...) (23 years ago, 6-Feb-02, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | Re: Sensor Connector
|
| I've bought some lego electric plates (part 5037) from lego.com, and they seem to be withstanding the heat of a soldering iorn quite well (that was my fear... that I would turn them into bubbling messes). Actually they're holding up better than the (...) (23 years ago, 6-Feb-02, to lugnet.robotics.handyboard)
|
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
