To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 6121 (+20)
  Re: Darn those definitions (was: The new Super Car)
 
(...) incorrect my friend. if water was not compressable at all there would be no pressure difference from the top to the bottom. Admittedly it is not very easy to do it, but it will compress. Most solids are compressable too. At hight pressures, (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Power steering for 8448
 
Has anyone used a motor to steer the new 8448? HOW?? I put the RCX in the trunk as everybody pointed out you could do. Then I tore off most of the body decorative pieces to make room to put in a motor to steer the car, so I can use sensors to keep (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  RE: Darn those definitions (was: The new Super Car) and ????
 
Patricia: Compressed solids have same weight and mass, only smaller dimensions (relative to its dimensions WITHOUT the compression forces). If you compress a lot but very a lot a gas it is transformed in LIQUID. The pressure of water (or Hg for that (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Darn those definitions (was: The new Super Car)
 
(...) Disregarding definitions for the moment and returning to the original question (can Lego rightly call those parts hydraulic), can we all agree on the following: 1) There is a large group of fluids whose volume changes *almost* linearly with (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: I/o's expansions for the mindstorm ?
 
(...) Yeah, I would really like to see such an expansion too! Someone was talking about an I2C bus interface, but the thread appearently died out - Is someone working on this?. I could also think of a "dummy RCX" which cannot be programmed but will (...) (27 years ago, 6-Aug-99, to lugnet.robotics)
 
  Re: Darn those definitions (was: The new Super Car)
 
What will actually happen, if you fill water into the LEGO pneumatic parts? Will they still work? And will they become hydrolics? Jacob -- Did you check the web site first?: (URL) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Power steering for 8448
 
(...) I don't have the 8448 myself (yet!). But I've been working with steering for quite a time now. I've experienced the steering motor tear a car apart also, and my solution was to add a rotaton sensor to the motor shaft, then gear it down by a (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  getting RCX datalog into a file
 
Is it possible to get the uploaded datalog from the RCX into a file using Rcx Command Center? (PS great work Dave and Mark!) Failing that, does someone have a *simple* (ie one which needs no interaction apart from giving a filename) Win95 prog. that (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: wireless communication to RCX
 
A simple way to overcome the unidirectional problem of the IR link is to build your robot with the RCX pointing up. Suspend the IR tower from the ceiling, pointing down. For a small room, this should cover the entire area. Only problem is when your (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: getting RCX datalog into a file
 
(...) My apologies - have just noticed the availability of RcxCC 2.3, which has this facility :-) Stuart -- Did you check the web site first?: (URL) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: I/o's expansions for the mindstorm ?
 
The mindstorm internals (very very good pages...) : (URL) has a section called "Communication". Here is the beginning : "The RCX uses a 38kHz carrier, which is pretty typical for TV remotes. As for the sampling rate, the RCX runs at 2400 bps, which (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Power steering for 8448
 
(...) The unfortunate thing with this approach is that you've used up 2/3 of your inputs just for steering. (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: wireless communication to RCX
 
Pete Sevcik wrote in message <37ADAB6F.4651EF8D@f...sh.net>... (...) build (...) ceiling, (...) How about putting up a lamp hanging from the ceiling in which you can hide the IR tower? I chuckled at first, when reading your posting, but thinking it (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  USB->serial adapter for IR-tower
 
Has anyone here tried using a USB->serial adapter for the IR-tower? I´m curious about this, since I have had bad experiences trying to expand the number of COM-ports on my machine (I have two on-board COM-ports, both used, now). Best regards, David (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: Darn those definitions (was: The new Super Car) (fwd)
 
Jim Choate wrote in message <199908071335.IAA293...sz.com>... (...) Hydraulics implies water(hydr). (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: USB->serial adapter for IR-tower
 
Yes. My RIS IR-tower functions (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: USB->serial adapter for IR-tower
 
Yes. My IR-tower works on the USB --> serial port of an Entrega 2U1S1P multiport USB adapter. The serial port configured itself as (COM3)USB, and the RIS software correctly autodetects COM3 (a pleasant surprise). Some other serial devices also (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: I/o's expansions for the mindstorm ?
 
(...) I tinkered with some multiplex schemes like this (URL) that simply connect different sensors to a single input in a fixed sequence. It workes OK for passive sensors like touch or temperature or voltage inputs. To make it work with active (...) (27 years ago, 8-Aug-99, to lugnet.robotics)
 
  Re: LA Area Robot-Arena competition may Not happen...
 
Hi: (...) IF you happen to be in the Toronto (Canada) area on Aug. 22 we have just such an event. you are very welcome (and encouraged). check out: (URL) my (new address) walker and lego tattoo page @ (URL) (27 years ago, 8-Aug-99, to lugnet.robotics, lugnet.loc.us.ca.sbe, lugnet.loc.us.ca.la, lugnet.robotics.events.robot-arena, lugnet.robotics.events)
 
  Re: LA Area Robot-Arena competition may Not happen...
 
sorry for the last post..... it was supposed to go to private e-mail. (I suck at this) BUT if you are interested....... (27 years ago, 8-Aug-99, to lugnet.robotics, lugnet.loc.us.ca.sbe, lugnet.loc.us.ca.la, lugnet.robotics.events.robot-arena, lugnet.robotics.events)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR