Subject:
|
Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 14 Jan 2005 06:56:45 GMT
|
Viewed:
|
2023 times
|
| |
|
|
In lugnet.robotics, Samarth Moray wrote:
| |
One question: Have you had problems with melting ABS? one would imagine
them melting at least a bit at that tempreature, given theyr’e so near the
heat.
|
Hello Samarth
Thanks for the comments. Me too, I was thinking I could have get some melting
problems. I did some gradually tests and to my surprised, despite the high heat
I damaged absolutely no parts!
The two support beam above are located to high, so they are out of danger. I
also have a pretty powerfull range hood, and needless to say it was working at
full power during the use of the Egglift. ;o)
As you can see on this picture, this sensor received some heat:
In lugnet.robotics, Khan wrote:
| |
About the ABS, I was searchin the web site of this german guy who did some
test on LEGo and to the melting point ... if someone kept it in his bookmarks
..
|
I know exactly what what you’re talking about! I made some search but didn’t
found it do. :o( But if I recall these pictures were pretty painfull to watch!
;o)
|
|
Message has 3 Replies:
Message is in Reply To:
10 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
