Robotics : 23342


Robotics / 23342	23341 \| 23343

Subject:	Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
Newsgroups:	lugnet.robotics
Date:	Sat, 15 Jan 2005 02:14:38 GMT
Viewed:	1869 times

In lugnet.robotics, Chris Caron wrote:

In lugnet.robotics, Samarth Moray wrote:

One question: Have you had problems with melting ABS? one would imagine them melting at least a bit at that tempreature, given theyr’e so near the heat.

Thanks for the comments. Me too, I was thinking I could have get some melting problems. I did some gradually tests and to my surprised, despite the high heat I damaged absolutely no parts!

As you can see on this picture, this sensor received some heat:

Phew, I can feel the heat! What was the reading recorded by the temperature sensor?

As I recall the LEGO Temperature sensor range is from -20 degrees Celsius to +50 degrees Celsius.

Would the sensor go off range or would the ABS melt first?

CS

Message has 1 Reply:

		Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
(...) The range of the Lego temperature Sensor is -20o C to 70 o C. You can see one reading below. As you can see, I'm almost off limit. (URL) (...) From my test, definitely the sensor would go off range first. Probably that's the reason why TLC (...) (19 years ago, 15-Jan-05, to lugnet.robotics, FTX)

Message is in Reply To:

		Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
(...) Hello Samarth Thanks for the comments. Me too, I was thinking I could have get some melting problems. I did some gradually tests and to my surprised, despite the high heat I damaged absolutely no parts! The two support beam above are located (...) (19 years ago, 14-Jan-05, to lugnet.robotics, FTX)

10 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search