To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 20024
20023  |  20025
Subject: 
Re: I2C device for the RCX
Newsgroups: 
lugnet.robotics
Date: 
Sun, 12 Jan 2003 11:13:15 GMT
Viewed: 
814 times
  
In lugnet.robotics, Steve Baker <sjbaker1@airmail.net> writes:
Bastiaan v.Kesteren wrote:

1.bus free time,min 4.7us =0.47ms,in BrickOS program 1 ms

  Erm...no...you have some trouble with your numbers!

  1000us == 1ms

  so:

   4.7us == 0.0047ms !!

OK, stupid of me!


2.START condition set-up time,min 4.7us =0.47ms,in BrickOS program 2 ms
3.START condition hold time,min 4.0us =0.40ms,in BrickOS program 1 ms
4.STOP condition set-up time,min 4.0us =0.40ms,in BrickOS program 1 ms
5.SCL low time,min 4.7us =0.47ms,in BrickOS program 2 ms
6.SCL high time,min 4.0us =0.47ms,in BrickOS program 2 ms
7.data set-up time,min 250ns =2.5ms,in BrickOS program 2 ms

Yikes! Nooooooooo!

  250ns == 0.25us == 0.00025ms

even more stupid.....
Maybe I should go back to primary-school for a while to learn those things
again (-:


anyway, thanks for the suggestions.



Message is in Reply To:
  Re: I2C device for the RCX
 
(...) Erm...no...you have some trouble with your numbers! 1000us == 1ms so: 4.7us == 0.0047ms !! (...) Yikes! Nooo...ooo! 250ns == 0.25us == 0.00025ms Remember: ms is a millisecond which is 1/1000th second. us is a microsecond which is 1/1000000th (...) (22 years ago, 11-Jan-03, to lugnet.robotics)

24 Messages in This Thread:









Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR